Jack Lift Ton

2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed


2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed
2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed

2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed    2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed

2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift TUV CE. The scissor jack, with tooth gears, can extend from 85mm(close position) to 330mm, more than enough to lift most vehicles. Easy to operate using the chromed crank with speed handle. Item Size: 35.58.28.5CM.

Study, understand and follow all instructions before operating this device. Do not exceed rated capacity as designated by the height/capacity curve. Use only on hard level surface. Use for emergency tire changing only.

Never get beneath the vehicle when it is supported by the jack. Activate the hazard warning flasher, turn off ignition, set parking brake, move automatic shift selector to park position. In case of a manual transmission, move gear selector into reverse position. In addition, the wheel diagonally opposite from the wheel being lifted shall be chocked in both directions. No alterations shall be made to this product.

Failure to heed these messages may result in personal injury and/or property damage. This device is designed to sustain the following loads at these specified heights.

DO NOT EXCEED the rated capacity for each position. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts.

Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock. If the jack is found to be damaged, it should be removed from service until properly repaired. Insert the jack handle into the hole of the handle socket. Make sure that the saddle is correctly positioned.

To prevent damage to the jack, do not move the jack while the handle is intact in the socket. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly. When jack is not in use, lifting arm should be in full down position.

Always keep jack clean and keep the screw and bearings well lubricated. Store the handle with care. This item is in the category "Vehicle Parts & Accessories\Garage Equipment & Tools\Workshop Equipment & Supplies\Jacks & Jack Stands".

The seller is "shiraz-market" and is located in this country: GB. This item can be shipped to United Kingdom.

  1. Brand: Unbranded
  2. Type: Trolley Jack
  3. Drive: Hydraulic


2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed    2 Ton Hydraulic Trolley Floor Jack Car Van Garage 2000kg Lift brand new sealed